- Black anodized finish with insulated hand grips. Crimp slot on end of tool secures most ignition terminals including "W" type, right angle and "High Tower" terminals. Crimps 7mm to 8.5mm ignition wire.Works with 10 to 22 guage solderless terminals. Great tool for crimping the ends on Dyna spark plug wires WARNING: Disconnect power source before using this tool! Keyword: Crimper

$12.00 Ea

- OEM: DC3-1 DYDC3-1. 3 ohm green coils. Replacement for factory coils. Matched to the Dyna-S Electronic Ignitions. Fatter spark means smoother running and less chance of fouling a plug. See below for plug wires. Check the resistance of the coils you are replacing to ensure a correct match. These coils work to replace some point system coils where the resistance is in the low to mid 3 ohm range. For some Kawasaki bikes with a resistor in the circuit (i.e. KZ1000's in the late 70's and early 80

$130.00 Ea

- DC3-2 (used with twin cylinder bikes fitted with two single output coil) 3 ohm mini black coil. Smaller and lighter than the DC3-1 coils, these are ideal for drag racing applications. Fatter spark means smoother running and less chance of fouling a plug. See below for plug wires. Check the resistance of the coils you are replacing to ensure a correct match. For some Kawasaki bikes with a ballast resistor in the circuit, the 3 ohm coil is the best choice - just remove the ballast resistor from t

$137.00 Ea

- DC3-2 (used with twin cylinder bikes fitted with one single output coil) 3 ohm mini black coil. Smaller and lighter than the DC3-1 coils, these are ideal for drag racing applications. Fatter spark means smoother running and less chance of fouling a plug. See below for plug wires. Check the resistance of the coils you are replacing to ensure a correct match. For some Kawasaki bikes with a ballast resistor in the circuit, the 3 ohm coil is the best choice - just remove the ballast resistor from t

$70.50 Ea

- Dyna Mini Shift Light is used in conjunction with Dyna Shift Minder System.

$51.00 Ea

- Dyna Mini Shift Light is used in conjunction with Dyna Shift Minder System.

$51.00 Ea

- Dyna Mini Shift Light is used in conjunction with Dyna Shift Minder System.

$51.00 Ea

- Dyna Mini Shift Light is used in conjunction with Dyna Shift Minder System.

$51.00 Ea

- Dyna Mini Shift Light is used in conjunction with Dyna Shift Minder System.

$51.00 Ea

- Timing/Work Light Self Powered - Combines timing light and work light into one instrument. Works on all 12-volt gasoline powered engines. Uses 2 "D" cell batteries. Includes an LED indicator to insure proper hook up or detects a faulty flash tube.

$87.20 Ea

- Equivalent to OEM: 90890-03112- Professional Analog Multimeter, check ignition and electrical system. Check resistance, voltage and more... Comes with test leads (red/black) and instructions (includes battery) this is a quality Yamaha part but it can be used on any motorcycle. A vital tool in checking electrical components - including wiring harnesses, coils, charging systems etc.

$183.70 Ea

- OEM: 8337 Black 7mm Spark Plug Wire - Stranded, non-suppression - Sold by the foot - 8 foot will be plenty for most 4-cylinder bikes.

$0.99 Ea

- OEM: LB05F Black NGK Resistor plug cap, 90 degree - for 14mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$2.24 Ea

- OEM: LD05F Black NGK Resistor plug cap, 90 degree - for 12mm or 10mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$2.24 Ea

- OEM: SD05F Black NGK Resistor plug cap, straight - for 12mm or 10mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea

- OEM: SB05F Black NGK Resistor plug cap straight - for 14mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea

- OEM: XD05F Black NGK Resistor plug cap, 102 degree elbow, long style - for 12mm or 10mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea

- OEM: XB05F Black NGK Resistor plug cap, 102 degree elbow, long style - for 14mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea

- OEM: VD05F Black NGK Resistor plug cap, 120 degree elbow, long style - for 12mm or 10mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea

- OEM: VB05F Black NGK Resistor plug cap, 120 degree elbow, long style - for 14mm thread spark plugs with terminal stud. Rubber waterproof boot to seal out the elements. See spark plug guide on lower right of page for more information on spark plugs and spark plug caps.

$3.06 Ea