Search by Motorcycle
Search by Motorcycle

Dyna Single Output 3.0 Ohm Coils (pair) DC3-1

$151.19 151.19
In stock
Only 7 left
Part
DYDC3-1
OEM: DC3-1 DYDC3-1. 3 ohm green coils. Replacement for factory coils. Matched to the Dyna-S Electronic Ignitions. Fatter spark means smoother running and less chance of fouling a plug. See below for plug wires. Check the resistance of the coils you are replacing to ensure a correct match. These coils work to replace some point system coils where the resistance is in the low to mid 3 ohm range. For some Kawasaki bikes with a resistor in the circuit (i.e. KZ1000's in the late 70's and early 80's)- the 3 ohm coil is the best choice - just remove the ballast resistor from the circuit. If you have questions if these are correct- please call us or Dynatek at 1-800-928-3962 Never select a coil with a lower resistance than your ignition system - this will cause the coils to overheat and burn out... It is OK to select coils with a slightly higher resistance. For example 3.0 ohm coils with a 1.5 ohm CDI ignition. While this isn't optimal- it works and allows you to switch your CDI ignition over to a Dyna-S in the future. Used on Twin cylinder motorcycles with 2 single coils- or Triples with 3 single coils- or used on 4 cylinder motorcycles using a Dyna 4000 setup.

Mount spacing center-to-center: 3.5" (90mm)- or 4" (102mm).

Is Universal Part: No

OEM Number(s): N/A

Motorcycle Fitment: N/A