This bolt-on replacement for the stock regulator & rectifier solves the problem of overcharging batteries. There is no cutting or splicing required to install this combination unit.
This simple step-by-step installation guide will help you have this regulator/rectifier wired up in no time.
Compatible with the following Kawasaki models:
1973 Kawasaki Z1 Z1
1974 Kawasaki Z1 Z1-A
1975 Kawasaki Z1 Z1-B
Installation Instructions
Disconnect your stock regulator and rectifier and remove them from the frame, taking care with the bullet connectors.
You MUST remove the old rectifier (white connector block) from the electrical system. We have found it to be best practice to tape over the open white connector in the harness panel once it’s removed.
Bolt the 200-1006 unit in the place of the old regulator (under the battery box). You will need slightly longer mounting bolts for this combo unit. We have found that 6 x 25mm bolts do the trick.
Plug the green connector into the electrical panel. This connects the 3 yellow wires to the stator, while the brown wire is connected to the power side. Connect the two white wires normally going to the rectifier into the double female connector on this new combo unit. The black wire should be safely grounded to the engine ground point (behind the kickstarter pedal).
You have now installed your 200-1006 regulator/rectifier.
For further assistance, please contact us at customerservice@z1enterprises.com
