Pedal Anchor - Shift - Rear Brake - Offroad - Motion Pro

Pedal anchors also known as a brake snake are the perfect addition for every offroad rider whether track or trail. They prevent your pedal from catching on berms / stumps / branches / rocks and keep all manner of debris from wedging between your pedal and engine case or frame. This can cause all manner of havoc from rendering your brake less effective to bending / braking or even ripping it clean off. This kit includes three cables / 3 special crimps / 12 inches of 1/8 inch clear PVC. You can fashion your anchor for most bikes in a few minutes and be ready to hit the track or trail with more confidence.

Instructions:

• 1 - Drill 1/16 in. hole in front outside part of brake pedal or shift lever.
• 2 - Thread cable up through hole in pedal until soldered end pulls up against pedal.
• 3 - Slide tubing over cable.
• 4 - Slide special crimp fitting onto cable.
• 5 - Find suitable location forward of the pedal on frame tube / motor mount / or pipe bracket for other end of cable. Loop cable around mount (you may have to drill additional 1/8 in. hole) and back through crimp fitting.
• 6 - Move pedal throughout complete travel making sure that cable does not impede movement. Use vise grips or suitable pliers and squeeze crimp fitting onto cable.